Need help?Do you have a question about the Frigidaire FFLE3911QW and is the answer not in the manual?
General| Appliance Category | Laundry Appliance |
|---|---|
| Type | Washer |
| Loading Type | Front Load |
| Capacity | 3.9 cu. ft. |
| Color | White |
| Brand | Frigidaire |
| Model Number | FFLE3911QW |
| Voltage | 120V |
| Drum Material | Stainless Steel |
| Control Type | Electronic |
| Number of Cycles | 12 |
| Number of Temperature Settings | 5 |
| Wrinkle Prevent Option | Yes |
| End of Cycle Signal | Yes |
| Lint Filter | Yes |
| Energy Star Certified | No |
| Appliance Type | Washer |
| Width | 27 Inch |
Outlines critical safety precautions for working with electrical appliances and potential hazards.
Details requirements and procedures for safe electrical hookup.
Instructions for safely connecting the gas supply to the dryer.
Information on accessing and using the diagnostic system for dryers.
Guide to troubleshooting dryer issues using alarm codes.
Troubleshooting steps for E31 alarm related to contact sensor issues.
Troubleshooting steps for E41 alarm indicating the door is open.
Troubleshooting steps for E51 alarm related to motor relay failure.
Troubleshooting steps for E52 alarm indicating a stuck motor relay.
Troubleshooting steps for E53 alarm when the motor stops mid-cycle.
Troubleshooting steps for E54 alarm concerning motor/heater components.
Troubleshooting steps for E55 alarm related to motor sensing on the main board.
Troubleshooting steps for E61 alarm related to heater relay failure.
Troubleshooting steps for E62 alarm indicating a heating timeout.
Troubleshooting steps for E65 alarm related to high limit thermostat trips.
Troubleshooting steps for E67 alarm related to heater sensing failure.
Troubleshooting steps for E71 alarm indicating an NTC open circuit.
Troubleshooting steps for E72 alarm indicating an NTC closed circuit.
Table summarizing alarm codes, faults, and actions.
Troubleshooting steps for E11 alarm related to water fill issues.
Troubleshooting steps for E13 alarm indicating water leakage.
Troubleshooting steps for E21 alarm related to draining issues.
Troubleshooting steps for E31 alarm related to pressure sensor faults.
Troubleshooting steps for E32 alarm related to pressure sensor calibration.
Troubleshooting steps for E35 alarm indicating water overload.
Troubleshooting steps for E41 alarm indicating the door/lid is open.
Troubleshooting steps for E42 alarm related to door/lid lock failure.
Troubleshooting steps for E43 alarm related to door/lid lock triac failure.
Troubleshooting steps for E44 alarm related to door/lid closed sensing.
Troubleshooting steps for E45 alarm related to door/lid triac sensing.
Troubleshooting steps for E55 alarm indicating motor under-speed.
Troubleshooting steps for E58 alarm related to motor over current.
Troubleshooting steps for E59 alarm when motor is not following.
Troubleshooting steps for E5A alarm related to motor control overheating.
Troubleshooting steps for E5H alarm related to motor control under voltage.
Troubleshooting steps for E5C alarm related to motor control under voltage.
Troubleshooting steps for E71 alarm related to washing NTC failure.
Troubleshooting steps for EB1 alarm related to power supply frequency.
Troubleshooting steps for EB2 alarm related to high voltage.
Troubleshooting steps for EB3 alarm related to low voltage.
Troubleshooting steps for EC6 alarm related to clutch issues.
Troubleshooting steps for EC7 alarm related to clutch triac sensing.
To Next Page