134
Checks to perform:
Checks to perform:
E81
E81: Program selector / Encoder fault
E81
Main Board, wiring, Encoder and cycle selector/software faulty.
WARNING
Check that all the connectors are correctly inserted
Check whether the Wiring for the Selector Knobs is
properly connected?
NO
Correct the Wiring and repeat the Diagnostic Cycle to
check for any further alarms.
Replace the Electronic Control Board and check for any
further alarms.
Y
E
S
Replace selector and modiļ¬er switches and repeat the
Diagnostic Cycle to check for any further alarms. Does
the same Error Code still appear?
YES
E82
E82: Key stuck
E82
Key Stuck error, wiring, cycle selector switch, main board and software defect.
WARNING
Check that all the connectors are correctly inserted
Remove the selector and knob and restart the dryer.
Does the problem exist?
NO
Replace the selector and knob, and check for any
further alarms.
Check whether the Wiring for Selector and Knob are
connected properly?
Correct the Wiring and repeat the Diagnostic Cycle to
check for any further alarms.
NO
Y
E
S
Replace the Electronic Control Board and repeat the
Diagnostic Cycle to check for any further alarms.
Y
E
S
To Next Page
Loading...
Need help?
General
