22
CLEANING AND CARE
Disconnect the power cord or leave the door open to deactivate the oven
during cleaning. Disconnect the power cord before replacing filters and lights.
OVEN LIGHT REPLACEMENT
Remove the vent grill (see steps 1-4 in charcoal
filter replacement section.
• Remove the screw and remove the lamp cover.
• Remove the LED bracket and light assembly.
Remove the LED light from the bracket by
removing the mounting screw and replace only
with part 5304499540.
To order parts call 800-599-7569.
• Re-install LED light to the bracket with mount-
ing screw.
When re-installing mounting screw be careful
not to damage the LED light.
• Reconnect LED light to the harness and place
the LED light assembly back into the plastic
housing.
• Replace the microwave oven light cover by
carefully pushing into place (make sure the light
cover rear tab is inserted into slot at rear),
replace the screw.
• Replace the charcoal filter (if installed).
Push the vent grill back into place (engaging
both the bottom and top tabs) and replace the
vent grill mounting screws.
To Next Page
Loading...
