CLEANING AND CARE 21
Disconnect the power cord or leave the door open to deactivate the oven
during cleaning. Disconnect the power cord before replacing filters and lights.
• Unplug the LED light from the harness, replace
with part 5304499540.To order parts call
800-599-7569.Then reconnect the harness.
• Re-install LED light and mounting screw.
When re-installing mounting screw be careful
not to damage the LED light.
• Re-install LED light cover and mounting screw.
• Plug the microwave back into the power supply
or turn the power back on at the main circuit
breaker.
• Disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
• Press the " Push" position on the cover.
• And then open the cover.
CHARCOAL FILTER REPLACEMENT
Charcoal filter part number
FRPAMRAF
To order parts call 800-599-7569
Charcoal Filter when installed in your microwave
oven, is used for nonvented, recirculated
Installation. When it is time to replace the charcoal
filter, the FILTER light on display will turn on.
If your microwave is vented to the outside, then
you can turn off the filter light in the settings.
• Remove the charcoal filter by pushing the top of
the filter inwards, then pull it forward out from
the unit.
• Slide the top of the new charcoal filter into the
top area of the filter cavity.
• Press the bottom of charcoal filter to place it
into the correct position.
• Press the "Push" to close the cover.
To Next Page
Loading...
