Getting Started
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid (See Rinse Aid).
4. Select desired CYCLE(See Cycle Chart). The
indicator light above the pad will glow when
selected.
5. Select desired OPTIONS (See Energy Options). The
indicator light above the pad will glow when
selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
The dishwasher is programmed to remember your last cycle
Options Selections
Hi-Temp Wash
When HI-TEMP WASH option isselected, the dishwasher
heats water in the main wash to approximately 140°F
(60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil from
dishes more effectively and aids in drying. This option is
available in NORMALWASH and LIGHT WASH. HI-TEMP
WASH is automatically provided when POWER PLUScycle is
selected.
so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on
the previous wash, just press the START/CANCELpad.
Wash Cycle Selections
Cycle times are approximate and will vary with options
selected. Hot water is necessary to activate dishwasher
detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature and, if it is
not hot enough, the timer will be delayed for automatic
water heating in the main wash of all cycles. This
happens even when HI-TEMP WASH option has not been
selected. When HI-TEMP WASH is selected, an even
higher temperature will be guaranteed to handle heavier
soil loads.
To Next Page
Loading...
