Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above the pad
will come on and remain on until end of cycle. The water
temperature in the final rinse will be raised to 155°F
(68°C) assuring bacteria is destroyed. This option is
available in POWER PLUS, NORMALWASH and LIGHT
WASH. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper water
temperature is reached. Washing action will continue
during the water heating delay. For best results, the
incoming water temperature should be at least 120°F
(49°C).
The sanitize criteria may not be satisfied if there is an
interruption of the cycle, power failure or if the incoming
water temperature is below 120°F (49°C).
To turn off the SANITIZE option, press the pad a second
time. The light above the pad will turn off.
Air Dry
The unit defaults to heated dry when it isstarted with any
cycle selected. This drying uses a combination of the
heated dry with rinse aid that achieves enhanced drying
performance. If you prefer to only have AIR DRYfor dishes,
you will select AIR DRYand the unit will not energize the
heating element. This will reduce energy consumption, but
reduce drying perfomance.
Delay Start
The DELAY STARToption allows you to automatically delay
starting your dishwasher from 1-24 hours.
On models with 1-24 hour delay, press the DELAY START
pad until the desired delay time shows in the STATUS
window. A light will come on indicating the delay start hours
and will remain on until cycle starts.
To cancel the DELAY STARToption and begin the cycle
before the delay period is over, press the START/CANCEL
pad.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle. Press
START/CANCEL pad and the dishwasher will start a 60
second drain. At the end of the drain, select the desired
cycle.
When an option is selected, the light above the pad will
come on and remain on until end of cycle. To turn off the
option, press the pad a second time. The light above the
pad will turn off.
Child Lock Controls
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock the
dishwasher controls by pressing and releasing the DELAY
START pad for 3 seconds. An indicator light on the lock
graphic pad will illuminate when the controls are locked
and no new selections can be made until the lock is
released. To unlock the controls, press the DELAYSTART
pad until the indicator light goes out.
To Next Page
Loading...
Need help?
General
