Frigidaire FPRU19F8RF User Manual

7
To Level the Refrigerator:
While unit is lying on its back, note the location
of the four (4) leg levelers installed at each
corner. These leg levelers will be used to level
the refrigerator and to adjust the height. Use a
carpenter’s level to level the refrigerator from
front to back and side to side. Adjust the plastic
leveling feet in front, ½ bubble higher, so that
the door closes easily when left halfway open.
Kick Plate Removal
To remove the kick plate, use a Phillips head
screwdriver and remove the two screws
holding the kick plate to the cabinet. Then pull
the kick plate away from the unit.
Leveling
The refrigerator must have all bottom corners
resting rmly on a solid oor.
The oor must be strong enough to support a
fully loaded refrigerator.
It is VERY IMPORTANT for your refrigerator
to be level in order to function properly. If the
refrigerator is not leveled during installation,
the door may be misaligned and not close
or seal properly, causing cooling, frost or
moisture problems.
Leveling Instructions for Matching
Refrigerator / Freezer Pair:
• Level door of rst unit using all four
levelers and slide unit into place. Recheck
for levelness and adjust if necessary.
• Measure distance from oor to bottom of
door on rst unit. Adjust and level second
unit so door height matches.
Leg Level Adjustments:
• One full turn of all four leg levelers will
raise door 5/32”.
• Slide second unit into place leaving a
minimum gap of 3/16” between units for
door swing clearance.
• This last step may require at least one
extraction of the second unit to properly
align units in a “built-in” application.
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to ne tune
the door height and for nal cabinet spacing.
Use a 7/16” socket or wrench to adjust the
screw at the bottom of the lower hinge.
Door
Raise
Door
Raise
Door
Slotted Hinge
Adjustment
⅜” bolts
Freezer Refrigerator
Screw
Door
INSTALLATION
Adjusting Doors for Matching
Refrigerator / Freezer Pair
The doors may also be adjusted side to
side with the slotted hinge for aligning the
doors parallel to each other. Loosen the two
bolts with a ⅜” wrench and one screw with
a Phillips screwdriver. Shift the doors until
parallel, then retighten the screw and bolts
securely. (See illustration below.)
Lower Hinge Adjustment for Leveling
the Doors of the Matching Refrigerator /
Freezer Pair
To level the doors using the adjustable lower
hinge (some models):
1. If the refrigerator door is lower than the
freezer door, raise the refrigerator door by
turning the adjustment screw clockwise
using a 7/16” socket wrench.
(See illustration below.)
2. If the freezer door is lower than the
refrigerator door, raise the freezer door by
turning the adjustment screw clockwise
using a 7/16” socket wrench.
(See illustration below.)
Kick Plate Removal

Frigidaire FPRU19F8RF Specifications

General

Child lock	Yes
Door hinge	Right
Control type	Buttons
Product color	Grey, Stainless steel
Housing material	Stainless steel
Reversible doors	No
Appliance placement	Freestanding
Fridge door balconies	7
Number of vegetable drawers	1
Fridge number of shelves/baskets	3
Noise level	- dB
Certification	Star-K, CSA
Climate class	-
Fridge net capacity	526 L
Fridge gross capacity	538 L
Lamp type	LED
Cord length	1.8 m
Current	20 A
Connected load	- W
AC input voltage	115 V
AC input frequency	60 Hz
Annual energy consumption	331 kWh
Package weight	111130 g

Weight and Dimensions

Depth	673.1 mm
Width	812.8 mm
Height	1793 mm
Weight	104326 g
Depth with door open	1450 mm