The machine had been disinfectend
before departed from factory.
Cleaning the dispenser prior to
installing a full bottle of water for the
first time.
Cleaning and draining
instruction
1) Before cleaning, make sure the
power switch in the "0"(off) position
and unplug the water dispenser.
2) Vertically insert the bottle into the
supporter on top of the machine.
3) Open the taps, let about 1 liter
water flows into a container.
4) Removed the water bottle from the dispenser.
5) Place a large bucket beneath the drain outlet.
Remove the drain cover and allow water to
drain.
6) After draining, replace the drain cover and
you can use the machine.
The dispenser heats water to a temperature of approximately 90°C.
It can caus severe scalded. Please operate it carefully.
Cleaning and maintenance
ENG
ENG
25
26
Attention
To Next Page
Loading...
