Installation
Base
foamed
cushion
04
Remove package
• Remove package and take out the
bottom board of the cabinet on the
foam cover.
• Open the lid of washer's door and
take out accessories.
• A trial operation or washing on the
foamed cushion is strictly forbidden.
Installation of drain hose
• Completely sleeve the drain hose
over the sewer.
• Fix and tighten it with a hoop (As
shown in the figure).
Installation of bottom cover
Slightly tilt the washing machine to the
front, and insert the bottom cover.
2423
ENG
ENG
Installation of water inlet hose
Fasten one end of the inlet hose to
the tap (there is arubber sealing
washer insider).
Tightly screw another end of water
inlet hose on water inlet valve (with
rubber seal ring inside).
When tightening the clamping nut, evenly apply the force and do not twist the
water inlet valve to avoid breaking of water inlet valve joint.
Water inlet
hose
Clamping
nut
Attention
To Next Page
Loading...
Need help?
General
