Operating Instructions
Operating Instructions
(continued)
11
.devreser sthgir llA.cnI ,stcudorP emoH xulortcelE 9002
Note: The error code will be seperated to 2 part and shown in the display alternately in 1 second intervals, for example, when
the fault code “EH03” occur, the panel will first display “EH” for 1 sec, then display “03” for another sec and keep repeatedly
showing “EH” and “03” until the issue are solved.
When below error code show on the display, please contact your Authorized Frigidaire Service Center.
Error Code Description
EH03
EC51
EC52
EC53
EC54
EH60
EH61
EC07
EH0b
EL0C
PC00
PC01
PC02
PC04
PC0L
Internal motor(fan motor) loss speed
Outdoor unit EEPROM malfunction
Outdoor condenser temperature sensor is open/short circuited
Outdoor ambient temperature sensor is open/short circuited
Outdoor discharge temperature sensor is open/short circuited
Indoor ambient temperature sensor is open/short circuited
Indoor evaporator temperature sensor is open/short circuited
Internal motor(fan motor) loss speed/outdoor motor loss speed/Compressor starting anomaly/outdoor
unit was stolen
Communication malfunction
Refrigerant detection failure
Outdoor IPM unit protection
Outdoor voltage protection
Compressor top temperature Protection (IPM) module temperature protection
Outdoor compressor feedback protection
Outdoor cryogenic protection
FAULT CODES:
SHOW “EH” FOR ONE SECONDS: THEN SHOW “03” FOR ANOTHER SECONDS:
TO CHANGE TEMPERATURE DISPLAY:
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
YOU WILL SEE:
DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
SIMULTANEOUSLY FOR 3 SECONDS
To Next Page
Loading...
Need help?
General
