Checkfor leaks. Leaktestingof theapplianceshallbe
conductedaccordingtothemanufacturer'sinstructions.
Afterconnectingthecooktoptothegassupply,check
tilesystemfor leakswithamanometer.Ifa manometer
isnotavailable,turnonthegassupplyandusealiquid
leakdetector(orsoapandwater)atalljointsand
connectionsto checkfor leaks.
Donotuseaflameto checkfor leaks
fromgasconnections.Checkingfor leakswithaflame
mayresultinafireorexplosion.
Tightena[[connectionsif necessaryto preventgas
leakageinthecooktopor supplyline.
Checkalignmentof valvesafterconnectingthe
cooktoptothegassupplyto besurethecooktop
manifoldpipehasnotbeenmoved.
Disconnectthis cooktopandits individualshutoff
valvefromtilegassupplypipingsystemduringany
pressuretestingof thatsystemattestpressuresgreater
thanY2psig(3.5kPaor 14" (35.6cm)watercolumn).
Isolatethe cooktopfrom the gassupplypiping
systembyclosingitsindividualmanualshutoffvalve
duringanypressuretestingof tilegassupplypiping
systemattestpressuresequalto or lessthanY2psig
(3.5 kPa or 14" (35.6 cm) water column).
7, Connect Electricity to Gas
Cooktop
Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension cord with this cooktop.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
Tile power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 8) to
minimize the possibility of electric shock hazard from the
appliance.
Preferred Method
Grounding
type wall
receptacle Power supply cord with
3-prong grounding plug
Figure 10
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
8. Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
Install Burner Caps
This cooktop is equipped with sealed burners as
shown (see Figure 11).
T--y
Burner Base-_
Burner Pan /
Built-in) ',
\
Gas Opening
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
/
Electrode --/
Figure 11
7
To Next Page
Loading...
