FRIGOGLASS Flex 20 HC - Troubleshooting Common Issues; Accident Response

ENG
10
FAULT POSSIBLE REASONS HANDLING
The ICM does not
work.
Power cord not plugged in. Plug it in.
No power coming through the socket. Check the outlet fuse.
The cooler does
not cool.
The ICM has recently been reloaded
with warm products. Please note that it
takes some time to cool warm
products.
Preferably, reload the ICM before night
closing.
The ICM is loaded in such a way that
the air circulation in the interior is
getting blocked.
Load the ICM according to the
standards you have been provided
with by the company.
The door does not seal properly.
Repair the doors for proper closing
(this type of repair should be
performed by an authorized
technician).
The cooler does
not cool.
Leakage in the cooling system.
Repair the leakage (this type of repair
should be performed by an authorized
technician).
The ICM makes
noise.
Intense metallic noise. Call a Service technician.
Inclined or curved floor.
Level the ICM properly by adjusting its
feet. Placing a spirit level on the top of
the ICM will assist you in leveling it.
There is water on
the floor.
The drainage hole for the condensate
water is blocked.
Unblock the drainage hole.
There is a leakage in the tray. Call a Service technician.
The lights don’t
work.
The lighting or the transformer are out
of order.
Call a Service technician.
If after all the above-mentioned checks the problem with your ICM remains, contact the customer
service department of your supplier and provide the following information:
 Type of ICM
 Serial number of the ICM
 Brief description of the problem / observation
6. First Aid
In case of accident, proceed to the following:
ACCIDENT IMMEDIATE ACTION
Inhalation of refrigerant
Take deep breaths of clean air. If irritation persists, contact a
doctor.
Contact with eyes
Wash your eyes thoroughly with plenty of water for at least 15 minutes
and then consult a doctor.
Contact with skin Wash immediately with water.