FRIGOGLASS MAX-1000 SD [R290] C

Questions and Answers

V
vanessa46Aug 10, 2025
What to do if FRIGOGLASS MAX-1000 SD [R290] C cooler does not cool enough and products are warm?
- C
  Carolyn ZunigaAug 10, 2025
  If your FRIGOGLASS Commercial Food Equipment cooler isn't cooling adequately and the products inside are warm, consider these potential causes and solutions: * Ensure the thermostat is correctly set by rotating the knob clockwise. * If you've recently reloaded the ICM with warm products, remember it can take 8-16 hours to cool them down. It's best to reload before closing time. * Check that the air circulation inside the ICM isn't blocked by the way it's loaded. Follow the company's loading standards. * If the door doesn't seal properly, it may require repair by an authorized technician. * A leakage in the cooling system may require repair by an authorized technician.
D
Dean RuizAug 18, 2025
Why is there water on the floor near my FRIGOGLASS MAX-1000 SD [R290] C?
- D
  Daniel Williams Jr.Aug 18, 2025
  If you find water on the floor near your FRIGOGLASS Commercial Food Equipment, it could be due to: * A blocked drainage hole for condensate water. Try unblocking the drainage hole. * A leakage in the tray. In this case, you should call a service technician.
J
John LamAug 26, 2025
Why is my FRIGOGLASS MAX-1000 SD [R290] C Commercial Food Equipment making noise?
- D
  Duane OrrAug 26, 2025
  If your FRIGOGLASS Commercial Food Equipment is making noise, here’s what might be happening: * A certain amount of noise is unavoidable due to the powerful mechanism needed for this ice cold merchandiser, which operates dynamically. * Intense metallic noise requires a service technician. * If the floor is inclined or curved, level the ICM properly by adjusting its feet, using a spirit level to assist you.
V
Veronica FigueroaSep 2, 2025
What to do if the lights don’t work in my FRIGOGLASS MAX-1000 SD [R290] C Commercial Food Equipment?
- A
  Anna DukeSep 2, 2025
  If the lights in your FRIGOGLASS Commercial Food Equipment aren’t working, call a service technician, because the fluorescent tubes or ballast or starter may be out of order.