REMOVING AND CLEANING BEATER
Loosen the knob and remove the OR gasket.
Slide the beater upwards and remove the
scrapers.
Remove the bush positioned in the lower part of
the beater.
Immerse the previously disassembled
components into the tub with the sanitizer and
brush the surfaces with care. Pay special
attention to the inner part of the beater shaft
and the scraper blade fixing pins.
Handle the beater with great care: because of
its great weight, should it fall, it could cause
injuries to staff and damages to objects.
All the disassembled parts must remain soaking in the Ecolab P3 Topax-san sanitizer
(4% dilution) for at least 15’ before they are rinsed with plenty of cold drinking water.
To Next Page
Loading...
