Why my Frigomat Freezer does not start?
If your Frigomat Freezer isn't starting, even with the green LED on, there are several potential causes. First, ensure the master switch is closed. Next, check that the lid is properly lowered and assembled, or that the door is assembled on the machine. Verify that the power supply is correct. Finally, make sure the selector switch isn't set to “0”; it should be in position 1.
Why are Frigomat G60 Freezer batch freezing times longer?
If you notice that batch freezing times are longer than usual or the ice cream from your Frigomat Freezer appears wet, consider these points: * Ensure there is at least 30 cm of space between the rear of the machine and any wall or obstruction. * Verify the room temperature doesn't exceed 32°C. * Keep in mind that the machine operates best with a liquid mixture temperature of 4°C. Higher temperatures will naturally extend batch freezing times. Check the wear of the scrapers and replace them if needed. Also, confirm that the mixture is balanced correctly and that you're using the correct amount.
What to do if Frigomat G60 Freezer compressor functions intermittently?
If the compressor in your Frigomat Freezer is working on and off during the initial freezing stages, check the following: * For air-cooled models, the air condenser might be dirty or the fan might be defective. Clean the condenser with a brush and ensure the fan is working correctly. * For water-cooled models, ensure there is a sufficient water supply to the system the machine is connected to, and check the cocks.
What to do if Frigomat G60 does not extract the ice-cream?
If your Frigomat Freezer isn't extracting the ice cream, make sure the selector switch is set to position 2. If it is already in position 2, but the beater is turning in the wrong direction, contact a technician to invert the phases in the plug.
Why is my Frigomat G60 Freezer noisy during batch freezing?
If your Frigomat Freezer becomes noisy while freezing, it could be due to ice forming on the cylinder wall, indicating the ice cream is ready for extraction. Also, ensure that the quantity of mixture introduced into the cylinder is not lower than the minimum allowed.
How to fix too soft product in Frigomat G60?
If the product from your Frigomat Freezer is too soft, increase the batch freezing time by selecting a longer time on the timer.
How to fix too hard product in Frigomat G60 Freezer?
If the product from your Frigomat Freezer is too hard, decrease the batch freezing time by selecting a shorter time on the timer.
Severe risks to health, death, and permanent damage.
Serious risks to health, death, and permanent damage.
Risk of injuries or damage to the machine.
Ensures proper machine function and servicing.
Inspect for damage upon arrival and store within specified temperature and humidity.
Prohibits unauthorized maintenance; provides contact for authorized personnel.
Warns of electrocution risk from high voltage within the electrical box.
Defines machine application and operational constraints for safe and correct use.
Details requirements for electrical power, water supply, and positioning for activation.
Step-by-step guide for initiating the ice cream and slush freezing process.
Guidelines for daily cleaning to prevent bacterial growth and initial washing steps.
To Next Page
General