Why my Frigomat Freezer does not start?
If your Frigomat Freezer isn't starting, even with the green LED on, there are several potential causes. First, ensure the master switch is closed. Next, check that the lid is properly lowered and assembled, or that the door is assembled on the machine. Verify that the power supply is correct. Finally, make sure the selector switch isn't set to “0”; it should be in position 1.
Why are Frigomat Freezer batch freezing times longer?
If you notice that batch freezing times are longer than usual or the ice cream from your Frigomat Freezer appears wet, consider these points: * Ensure there is at least 30 cm of space between the rear of the machine and any wall or obstruction. * Verify the room temperature doesn't exceed 32°C. * Keep in mind that the machine operates best with a liquid mixture temperature of 4°C. Higher temperatures will naturally extend batch freezing times. Check the wear of the scrapers and replace them if needed. Also, confirm that the mixture is balanced correctly and that you're using the correct amount.
What to do if Frigomat G30 compressor functions intermittently?
If the compressor in your Frigomat Freezer is working on and off during the initial freezing stages, check the following: * For air-cooled models, the air condenser might be dirty or the fan might be defective. Clean the condenser with a brush and ensure the fan is working correctly. * For water-cooled models, ensure there is a sufficient water supply to the system the machine is connected to, and check the cocks.
What to do if Frigomat G30 does not extract the ice-cream?
If your Frigomat Freezer isn't extracting the ice cream, make sure the selector switch is set to position 2. If it is already in position 2, but the beater is turning in the wrong direction, contact a technician to invert the phases in the plug.
Why is my Frigomat G30 noisy during batch freezing?
If your Frigomat Freezer becomes noisy while freezing, it could be due to ice forming on the cylinder wall, indicating the ice cream is ready for extraction. Also, ensure that the quantity of mixture introduced into the cylinder is not lower than the minimum allowed.
How to fix too soft product in Frigomat G30 Freezer?
If the product from your Frigomat Freezer is too soft, increase the batch freezing time by selecting a longer time on the timer.
How to fix too hard product in Frigomat Freezer?
If the product from your Frigomat Freezer is too hard, decrease the batch freezing time by selecting a shorter time on the timer.
Explains DANGER, WARNING, CAUTION, ATTENTION, and SUGGESTION symbols for safe operation.
Warning about high voltage inside the electrical box and electrocution risk.
Explains the purpose and operation of each control panel button and switch.
Detailed steps for making ice cream and slush mixtures.
Procedures for daily cleaning, sanitizing, and upkeep of the machine.
To Next Page
General