Frigomat Taylor T5 S/s03

Questions and Answers

S
Sarah ShafferAug 7, 2025
What to do if my Frigomat Taylor T5 S/s03 Ice Cream Maker works properly but the product is not firm enough?
- J
  julierossAug 8, 2025
  If your Frigomat Ice Cream Maker is running but the ice cream isn't firm enough, consider these potential causes: * The mixture might be unbalanced, or you may have added too much. Ensure you're using the correct amount of a properly balanced mixture. * You might have selected the wrong work program. Try choosing a program that's better suited for the product you're making. * Check the beater scrapers for wear and replace them if needed. * Insufficient condensation could be the issue. Verify the installation conditions and ensure the ambient temperature doesn't exceed 35°C. * There could be an issue with the refrigeration system.
S
stewartchristopherAug 12, 2025
What to do if my Frigomat Ice Cream Maker works properly but the product is too firm?
- K
  Kaitlyn SimpsonAug 12, 2025
  If your Frigomat Ice Cream Maker is running, but the product comes out too firm, it could be due to a few reasons: * The mixture might be unbalanced, or you may have introduced too little of it. Check that the mixture is properly balanced and that you're using the correct amount. * The work program selection might be incorrect. Try selecting a work program that is more appropriate for the type of product you are trying to make.
M
Michael WuAug 17, 2025
Why Frigomat Taylor T5 S/s03 machine does not start (STOP button off)?
- J
  Jerry BrownAug 17, 2025
  If your Frigomat Ice Cream Maker isn't starting and the STOP button is off, the issue might be: * The master switch is open. In this case, close the switch. * There is an electrical anomaly. * The fuses are blown.
M
Megan GatesAug 22, 2025
What to do if my Frigomat Ice Cream Maker is noisy during product extraction?
- W
  weaverashleyAug 22, 2025
  If your Frigomat Ice Cream Maker becomes noisy during product extraction, it's likely due to excessive hardening of the product. To resolve this, make sure you press the “Estrazione” ("Extraction") key before emptying the cylinder.
D
Dr. Stacy Mccarty MDAug 27, 2025
What to do if my Frigomat Taylor T5 S/s03 works intermittently during cooling?
- A
  Alec SotoAug 27, 2025
  If your Frigomat Ice Cream Maker works intermittently during cooling, consider these potential causes: * For air-cooled machines: the air condenser might be dirty, or the fan could be faulty. Clean the condenser with a brush and check the fan's functionality. * For water-cooled machines: there might be no condensation water. Ensure there is water in the water system to which the machine is connected, and check the pipes and cocks.
T
Tony LeeSep 1, 2025
What to do if I see liquid ice cream in the drip drawer of my Frigomat Ice Cream Maker?
- V
  Valerie JamesSep 1, 2025
  If you find liquid ice cream in the drip drawer of your Frigomat Ice Cream Maker, it's likely because the beater gasket is either absent or worn. Check if the gasket is present and ensure it is not excessively worn.