Connect the FRITZ!Repeater 600 to the Wireless Router using the Wizard
If your wireless router does not support setup at the touch of a button (WPS), use the wizard to connect the FRITZ!Repeater with the wireless router.
1
Establishing a Connection to the Computer
1. Plug the FRITZ!Repeater into an outlet near your wireless router. The
FRITZ!Repeater starts operation.
2. Wait until the LED starts slowly fl ashing green.
3. Select the wireless radio network of your FRITZ!Repeater on the
computer, and start the connection process.
4. Enter the network key of the FRITZ!Repeater. The preconfi gured unique
network key is printed on the back of this guide and on the back of the
device housing.
The computer establishes a connection to the FRITZ!Repeater.
2
Run the Wizard
1. Open the web browser on your computer and enter
http://fritz.repeater in the address bar.
2. The confi guration wizard appears and guides you through setup of the
wireless connection between the FRITZ!Repeater and your wireless
router.
3. Insert the FRITZ!Repeater into an outlet located about halfway
between the wireless router and the wireless devices to be added to
the wireless network. The FRITZ!Repeater and your wireless router
connect once more.
LED lights up green: the FRITZ!Repeater has a good wireless
connection and is ready for operation.
LED lights up orange: the FRITZ!Repeater has a weak wireless LAN
connection. Insert the the FRITZ!Repeater into an outlet closer to the
wireless router.
LED fl ashing continuously orange: cannot connect via wireless LAN.
Insert the the FRITZ!Repeater into an outlet closer to the wireless
router.
1110
To Next Page
Loading...
