22
Fitting the cooling unit to the trolley
General remarks In order to increase the mobility of the entire welding machine incl. cooling unit, it is possi-
ble to mount the welding machine on a carriage.
NOTE!
The cooling unit is always installed on the bottom.
Mount cooling
unit on carriage
bottom
Switch mains switch in position “O“
Mount mounting angles with three Ex-
trude-Tite screws each on the carriage
bottom.
Place cooling unit on carriage bottom
Screw cooling unit with two Extrude-
Tite screws each to the front and rear
mounting angle on the carriage bot-
tom.
IMPORTANT!
The mounting of the power source on the carriage (without cooling unit) is identical
with the procedure described above.
To Next Page
Loading...