Home
Fronius
Cooling boxes
FK 2200
Page 36
Fronius FK 2200 - Page 36
36 pages
Manual
Save Page as PDF
To Previous Page
To Previous Page
Loading...
FRONIUS INTERNATIONAL GMBH
Froniusstraße 1, A-4643 Pettenbach, Austria
E-Mail: sales@fronius.com
www.fronius.com
Under
www.fronius.com/contact
you will
find the addresses
of all Fronius Sales & Service Partners and locations
35
Table of Contents
Main Page
Table of Contents
5
Safety Rules
7
General
7
Proper Use
7
Environmental Conditions
7
Obligations of the Operator
8
Obligations of Personnel
8
Mains Connection
8
Protecting Yourself and Others
8
Noise Emission Values
9
Danger from Toxic Gases and Vapours
9
Danger from Flying Sparks
10
Risks from Mains Current and Welding Current
10
Meandering Welding Currents
11
EMC Device Classifications
11
EMC Measures
12
EMF Measures
12
Specific Hazards
12
Requirement for the Shielding Gas
14
Danger from Shielding Gas Cylinders
14
Danger from Escaping Shielding Gas
14
Safety Measures at the Installation Location and During Transport
14
Safety Measures in Normal Operation
15
Commissioning, Maintenance and Repair
16
Safety Inspection
16
Disposal
16
Safety Symbols
16
Data Protection
16
Copyright
17
General
18
Equipment Concept
18
Overview
18
Area of Application
18
Information about the Coolant
18
Information on Leaks
19
Installation Kit "Flow Controller" with Water Filter
20
Installation Kit "Temperature Limit Controller
20
Options
20
Control Elements and Connections
21
Rear Side
21
Front Side
21
Fitting the Cooling Unit to the Trolley
22
General Remarks
22
Mount Cooling Unit on Carriage Bottom
22
Connecting the Cooling Unit to the Power Source
23
Connect Power Source with Cooling Unit
23
Transport of Cooling Unit and Power Source
23
Connecting the Welding Torch
24
Connect Welding Torch with Power Source
24
Connect Welding Torch with Cooling Unit
24
Putting the Cooling Unit into Service
25
Connect Welding Torch with Power Source
25
Guarantee Provisions Regarding the Coolant Pump
25
Information on the Coolant
25
Fill Cooling Unit
25
Purge Cooling Unit
25
Start Operation of Cooling Unit
26
Changing the Welding Torch
26
Care, Maintenance and Disposal
27
General Remarks
27
Safety
27
Symbols for Care and Maintenance of the Cooling Unit
27
Every Start-Up
28
Every Week
28
Every 2 Months
28
Every 6 Months
28
Every 6 Months for 3-Shift Operation with Ethanol-Based Coolant
29
Every 12 Months for Single-Shift Operation with Ethanol-Based Coolant
29
Every 12 Months in 3-Shift Operation with FCL 10/20 Coolant
29
Every 24 Months in Single-Shift Operation with FCL 10/20 Coolant
29
Applicability of the "General Terms of Delivery and Payment
29
Disposal
29
Troubleshooting
30
General Remarks
30
Technical Data
32
General
32
To Previous Page