Fronius iWave 300i - Threading in the Welding Wire

Threading in the welding wire
Threading in the
welding wire
CAUTION!
Danger due to sharp end of the welding wire.
Personal injury and damage to property may result..
▶
Deburr the end of the welding wire before insertion.
CAUTION!
Danger from springiness of the coiled welding wire.
Personal injury and damage to property may result.
▶
Wear safety goggles.
▶
When inserting the welding wire into the 4-roller drive, hold the end of the
welding wire firmly to avoid injuries caused by the welding wire springing
back.
4
3
1
NOTE!
The length of the wirefeeding hose must not exceed 4 m / 13 feet 1.48 inches
during active wire movement (Active Wire function).
WARNING!
Danger due to emerging welding wire.
This can result in severe personal injury and damage to property.
▶
Position the robot axis with the welding torch so that the emerging welding
wire points away from your face and body.
▶
Wear safety goggles.
190