Table of contents
Safety Instructions 7
Explanation of Safety Instructions 7
General 7
Intended Use 8
Environmental Conditions 8
Obligations of the Operating Company 8
Obligations of Personnel 8
Grid Connection 8
Personal Protection and Protection of Others 9
Danger from toxic gases and vapors 9
Danger from Flying Sparks 10
Risks from mains current and welding current 10
Stray welding currents 11
EMC Device Classifications 12
EMC measures 12
EMF measures 13
Particular hazard areas 13
Requirement for the shielding gas 14
Danger from Shielding Gas Cylinders 14
Danger Posed by Shielding Gas Leak 15
Safety Measures at the Setup Location and during Transport 15
Safety Measures in Normal Operation 16
Maintenance and repair 16
Safety inspection 17
Disposal 17
Safety symbols 17
Data backup 17
Copyright 17
System configurations 19
System configurations – conventional robot 21
Conventional robot – Push 21
Conventional robot – PushPull 23
Conventional robot – plasma 25
Conventional robot – ArcTIG 27
PowerSharing mode 28
Conventional robot – hot wire 29
System configurations – PAP 31
PAP robot – Push 31
PAP – Plasma 33
PAP – Hot wire 35
System components 37
CWF 25i R wirefeeder 39
Device concept 39
Intended Use 39
Notes on the device 40
Description of the warnings on the device 42
SplitBox hosepack SB TP 95i CON R 44
Device concept 44
Intended Use 44
Notes on the device 44
CrashBox/i TIG/PAP 46
Device concept 46
Note on the repair of CrashBoxes 46
CrashBox /i 47
Device concept 47
Note on the repair of CrashBoxes 47
TTB 450i / 500i W R robot welding torch 48
3
To Next Page
Loading...
