Fronius TransPuls Synergic 4000 - Page 164

PC board
No. Push-pull unit SR41 SR43
8 Binzel manual push-pull 42 V without power potentiometer x
9
Binzel robot push-pull 42 V
2)
x
10 Binzel robot push-pull 24 V x
11 Dinse robot push-pull 42 V x
12 Hulftegger manual push-pull 24 V x
13 Fronius “VR 143-2“ intermediate drive x
14
Fronius unreeling device “MS” 22 m/min / 865 ipm
1)
x
16 “Cobra Gold” manual push-pull 24 V x x
20
Fronius unreeling device "VR 1530-12“ 12 m/min / 470 ipm
1)
x
23 Binzel robot push-pull 32 V x
24 Dinse new robot push-pull 42V x
27 Robacta Drive CMT x
28 PullMig CMT with up/down button (CMT manual) x
29 PullMig CMT without up/down button (CMT manual) x
32 Robacta Powerdrive, 22 m/min x
33 Elvi, 25 m/min, 500 mA, slave x
34 Elvi, 25 m/min, 900 mA, slave x
35 Robacta Powerdrive, 10 m/min x
50 Fronius manual push-pull “PT Drive” (d=0.8 mm / 0.030 in.;
material: aluminium)
3)
x
51 Fronius manual push-pull “PT Drive” (d=1.0 mm / 0.040 in.;
material: aluminium)
3)
x
52 Fronius manual push-pull “PT Drive” (d=1.2 mm / 0.045 in.;
material: aluminium)
3)
x
53 Fronius manual push-pull “PT Drive” (d=1.6 mm / 1/16 in;
material: aluminium)
3)
x
54
Binzel robot push-pull “Master Feeder BG II”
1) 3)
x
55 Fronius “VR 1530 PD” unreeling device (d = 1.0 mm / 0.040
in.; material: steel)
3)
x
56 Fronius “VR 1530 PD” unreeling device (d = 1.2 mm / 0.045
in.; material: steel)
3)
x
57 Fronius “VR 1530 PD” unreeling device (d = 1.6 mm / 1/16 in.;
material: steel)
3)
x
59 Fronius manual push-pull “PT Drive” (d=1.0 mm / 0.040 in.;
materials: steel, CrNi, CuSi3)
3)
x
60 Fronius manual push-pull “PT Drive” (d=1.2 mm / 0.045 in.;
materials: steel, CrNi)
3)
x
61 Fronius manual push-pull “PT Drive” (d=0.8 mm / 0.030 in.;
materials: steel, CrNi)
3)
x
62
Binzel robot push-pull 32V with IWG
1) 3)
x
164
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044