Fronius TransPuls Synergic 4000 - Contact Pressure Setting Guidelines; Wirespool Brake Adjustment

1
2
4
5
3
5
1
1
2
3
6
Setting the con-
tact pressure
1
1
NOTE!
Set the contact pressure in such a way
that the wire electrode is not deformed
but nevertheless ensures that the wire
is transported properly.
Contact pressure stand-
ard values
Semi-cylindrical
rolls
Trapeze rolls Plastic rolls
Aluminium 1.5 - 3.5 - 4.5
Steel 3 - 4 1.5 -
CrNi 3 - 4 1.5 -
Adjusting the
brake
NOTE!
After releasing the torch trigger the wirespool should stop unreeling.
Adjust brake if necessary.
87
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044