Frontier BB5060 - Table of Contents; General Information

General Information 3
This Operator’s Manual should be regarded as part of the machine.
Suppliers of both new and second-hand machines must make sure
that this manual is provided with the machine.
TABLE OF CONTENTS
INTRODUCTION .............................................................................................. 2
GENERAL INFORMATION ................................................................................ 3
SPECIFICATIONS ........................................................................................... 4
SAFETY RULES ............................................................................................. 5-6
DEALER CHECK LISTS .................................................................................... 7
SAFETY DECALS ........................................................................................... 8-9
OPERATION ............................................................................................... 10-12
OWNER SERVICE...................................................................................... 12-13
PARTS LIST ................................................................................................ 14-15
BOLT TORQUE CHART .................................................................................. 16
BOLT SIZE CHART & ABBREVIATIONS ......................................................... 17
All information, illustrations and specications in this manual are based on
the latest information available at the time of publication. The right is
reserved to make changes at any time without notice.
The purpose of this manual is to assist you in operating
and maintaining your Box Blade. Read it carefully. It
furnishes information and instructions that will help
you achieve years of dependable performance.
These instructions have been compiled from
extensive eld experience and engineering data. Some
information may be general in nature, due to unknown
and varying operating conditions. However, through
experience and these instructions, you should be able
to develop procedures suitable to your particular
situation.
The illustrations and data used in this manual were
current at the time of printing. However, due to
possible inline production changes, your machine may
vary slightly in detail. We reserve the right to redesign
and change the machines as may be necessary without
notication.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the tractor facing the direction of forward
travel.
GENERAL INFORMATION