Bluetooth settings
All devices have a Bluetooth settings screen where you can:
• Pair devices
• Connect and disconnect
• Forget devices (the opposite of pairing)
There may also be alternate, easier ways of connecting and disconnecting without going to the settings.
NOTE: Your device experience may differ, depending on the model and version of the operating system.
Bluetooth on Mac
To pair or forget devices:
Go to System Preferences, then to the Bluetooth settings.
Bluetooth Button functions
Short press
Press and hold for
3 seconds
While in pairing mode
(LED is flashing):
Double-press
While in pairing mode
(LED is flashing):
Hold for 3 seconds
Puts ezRoom in pairing mode so that you can pair your devices. If using the CB55 wallplate, the
button will flash when in pairing mode. ezRoom will remain in pairing mode for 60 seconds.
“Reboots” the Bluetooth module. Use this if you are having trouble connecting to ezRoom.
Exits pairing mode.
Clears the list of paired devices and reboots the Bluetooth module. Use this as a last resort for
troubleshooting, or if unauthorized users have paired with Juno. You will need to pair all of your
devices again.
You can also use the menu bar Bluetooth icon to easily connect or disconnect from Juno.
Once paired, you can right click (or control click) to connect or
disconnect from ezRoom.
8
To Next Page
Loading...
