REQUIREMENTS FOR ELECTRICAL CONNECTION
The cabinet is connected by inserting the power plug in a socket.
The plug is fitted with a 13amp fuse. The cabinet has an ON/OFF
switch but we recommend the provision of a remote switch. Ask
you electrician.
The socket employed must be properly earthed, firmly installed
and protected by a 32amp circuit breaker type C.
Supply voltage and frequency must be in accordance with the
data shown on the cabinet type plate. The local utility
company’s regulations on earth fault protection must be
observed. If in doubt, consult a qualified electrician.
The cabinet must not be plugged into a multiple outlet power
strip.
Run the power cables so they are protected from risk of damage
and there is no risk of tripping.
STARTING
If the cabinet has been tilted sharply whilst being sited or for
counting of accessories, it must be left to stand for at least three
hours before being started to allow the lubricating oil to settle in
the compressor. Failure to do so can cause total destruction of
the refrigeration system.
Ensure the means of transporting/positioning used does not
damage elements which may exist in the lower part of the
equipment.
Start the cabinet only if installed as described.
- Plug power plug in socket
- Switch on
Starting is signalled by the running noise of fans and
refrigeration system.
To Next Page
Loading...