SETTING THE STORAGE TEMPERATURE
The temperature regulation parameters as well as recommended
defrost times for each case are based on Frost-Tech experience
and on the results obtained in laboratory tests.
Regulation which is different from those recommended may be
necessary for reasons of non-standard ambient and/or operating
conditions.
The units are delivered with the regulation already factory set.
ADJUSTING THE CONTROLLER
Please refer to the specific instructions included.
AUTOMATIC EVAPORATOR DEFROSTING
Defrosting of the evaporator fins and evaporation of the drip
water formed during the defrosting is performed automatically.
During automatic defrosting, the temperature in the display
compartment may rise slightly.
Defrost frequency as well as duration and time are factory set.
Defrosting is automatic four times a day.
All cabinets have a stainless steel drip tray with an electrical
heating element operated by a float switch, and a hot gas pipe
running under the tray to evaporate the condensate water.
To Next Page
Loading...