Fryette Power Station 100 User Manual

9
APPLICATION EXAMPLES
MAI NS IN PUT
SER IAL:
117 V
SPK R OUT
LIF T
GRO UND
POWE R STATIO N MODE L PS-10 0
STE VEN FR YETT E DESI GN, I NC.
AMP IN
IMPE DANCE
SELE CT
LINE OUT
BALA NCED
SPE AKER
2/4
8
16
2/4
8
16
200 W
MAX
FT SW
AMPL IFIER
FX S END LIN E IN
FX R ETN
FX
LEV EL
LIN E OUT
FUS E
MAI N
T4A
50/6 0 HZ
300 WATTS
AVIS: RISQU ES DE CHOC E LECTR IQUE , NE PAS OUVR IR:
WARNI NG: H AZAR DOUS VOLTAGE IN SIDE . REF ER
SERV ICING TO Q UALIFI ED SE RVIC E PERS ONNEL :
CAUTI ON: DO NOT EX POSE T HIS
EQUIPME NT TO
RAIN OR MOISTU RE:
CAUTI ON REP LACE O NLY
WITH S AME T YPE FU SE
UTILI SER U N FUSI BLE DE
ECHA NGE DE MEME T YPE
REFE R SERV ICIN G TO
QUALI FIED S ERVI CE PER SONN EL
NO US ER SER VICAB LE PAR TS INS IDE
LIN E
LEV EL
HI
LO
to input
on mixer
from PS100
FX loop
to PS100 FX loop
to PS100 line in
PS100 spkr out to cab in / 8 Ω
to input
on mixer
F
5. David Torn type setup for live performance and/or recording.
Power Station
OPERATE
VOL UME PRE SENC E DEPTH
BYPASS POWER
ON
Variable Reactive Load + Vacuum Tube Power PS-100
EDG E SE LECT
FL AT
BRI TE
DEE P LE VEL
FL AT
WAR M
®
HI
LO
Dua l - Mode Reactance Amplif ier
MAINS INPU T
SE RIA L:
117 V
SPK R OUT
LIF T
GRO UND
POW ER STATIO N MODEL PS-100
STE VEN F RYETT E DES IGN, I NC.
AMP IN
IMP EDANC E
SEL ECT
LIN E OUT
BALA NCED
SPE AKER
2/4
8
16
2/4
8
16
20 0W
MA X
FT S W
AMP LIFIE R
FX SEN D LIN E IN
FX RET N
FX
LE VEL
LIN E OUT
FUS E
MAIN
T4A
50/ 60 HZ
30 0 WATTS
AVIS : RISQ UES D E CHOC ELECT RIQU E, NE PA S OUV RIR:
WARN ING: H AZA RDOUS VO LTAGE INS IDE. REFE R
SER VICIN G TO QU ALIFI ED SE RVICE PERSO NNEL :
CAUTI ON: D O NOT E XPOS E THIS
EQUI PMEN T TO
RAI N OR M OISTU RE:
CAUTI ON RE PLACE ONLY
WITH SAME T YPE F USE
UTIL ISER UN FUS IBLE D E
ECHA NGE D E MEM E TYPE
REFE R SER VICI NG TO
QUAL IFIED SERV ICE PE RSON NEL
NO US ER SE RVICA BLE PA RTS IN SIDE
LIN E
LE VEL
HI
LO
Amp Speaker Out
All red outlined functions operate without power
No A/C power needed
XLR Line Out
to mixer
Standard ¼“ to ¼“
male speaker cable
4. Silent mode.
USING SILENT MODE
WHEN USING A HIGH-POWERED AMP
CRANKED, YOU MUST RUN THE POWER
STATION WITH THE AC CORD PLUGGED IN
AND THE POWER SWITCH TURNED ON.
IN THIS CASE, LEAVE THE OPRATE/BYPASS
SWITCH SET TO BYPASS.
Silent Mode allows you to use the Power
Station as a silent adjustable reactive load
for quiet direct recording or when sending
a live amp signal to front of house with no
speaker cab connected. In this mode it is not
necessary to power up the Power Station.
You don’t even need to plug in the power
cord. The Voicing switches, FX Send (along
CAUTION! The 200W maximum power ra-
ting of the Power Station’s load depends
on the fan being operational. Running the
Power Station with no AC power disables
the
fan and the Maximum Power rating is
reduced by 50%.
with the FX Level switch), Line Out, Line Level
control and the Balanced and Unbalanced
Line Outputs all operate with no AC power
supplied.

Fryette Power Station 100 Specifications

General

Brand	Fryette
Model	Power Station 100
Category	Amplifier
Language	English