EasyManuals Logo

Fryette Power Station 100 User Manual

Fryette Power Station 100
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
TROUBLESHOOTING GUIDE
SPECIFICATIONS
WON’TTURNON
1. Make sure AC cord is securely connected at
both ends.
2. Verify the power source with something you
know works.
3. Check the mains fuse, and replace if necessary.
If it blows again, refer to qualied service personnel.
NO SOUND
1. Check input cable.
2. Check volume controls.
3. Make sure the amplier volume and/or gain
controls are turned up.
4. Check to see if the effects loop is connected
correctly.
5. Check speaker cable to see if it is disconnected
or shorted.
6. Make sure that the impedance selector is fully
engaged in its detent.
7. Check the standby switch.
8. Check for a blown speaker.
9. Check the mains fuse, and replace if necessary.
If it blows again, refer to qualied service personnel.
WON’TSWITCHTOOPERATE
1. Check the mains fuse, and replace if neces-
sary. If it blows again, refer to qualied service
personnel.
SQUEEL / FEEDBACK
1. Move your guitar/pickups away from your amplier.
See Proximity Feedback info sheet at
www.fryette.com
EFFECTS NOT OPERATING
1. Make sure effects send and return cables are
good and properly connected.
2. Check footswitch/remote switcher cable (TRS).
RUNNING HOT
1. Make sure that the unit has adequate ventilation.
2. Make sure that the impedance selector is set to
the proper impedance.
3. Power tubes may be drawing excessive current
(refer to qualied service personnel).
NOTE: Always set the amplier to standby when
taking breaks and turn the amplier off when
not in use. This will extend tube life and improve
long term reliability.
DISTORTION
1. Check the impedance setting.
2. Check the speaker cable for shorts.
3. Check the speaker.
4. Check the signal level at other devices in the
signal path or in the loop.
5. Power tubes may be weak (refer to qualied
service personnel).
BLOWING MAINS FUSE
1. Bad power tube or other internal power supply
component (refer to qualied service personnel).
MODEL: POWER STATION 100
MODEL NUMBER: PS-100.
POWER REQUIREMENT: 300W
POWER AMP OUTPUT: 100W RMS @ 5% THD,
1kHz sine into 8Ω
INPUT IMPEDANCE: 2/4Ω/8Ω/16Ω (selectable)
OUTPUT IMPEDANCE: 2/4Ω/8Ω/16Ω (selectable)
FUSE:
100V-120V UNITS: T4A, 125/250V
220V-240VUNITS:T1.6A, 250V.
DIMENSIONS:
HEIGHT: 3.6 in (9.1 cm)
WIDTH: 14 in (35.5 cm)
DEPTH: 9 in (22.8 cm)
WEIGHT: 16 lb (7.3 kg)
Product specications are subject to change without notice.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fryette Power Station 100 and is the answer not in the manual?

Fryette Power Station 100 Specifications

General IconGeneral
BrandFryette
ModelPower Station 100
CategoryAmplifier
LanguageEnglish

Related product manuals