N8560-32C
1. Hold the handle at the end of the fan module, then press the blue clasp and withdraw the fan
module slowly.
2. Hold the handle at the end of the new fan module, then press the blue clasp and Insert the fan
module to the chassis slowly until it is fully seated, and make sure that it is in good contact with the
slot.
NOTE: 1. If the screws cannot be tightened, it is probably because the fan module is not
fully inserted. Please check it carefully.
2. The fan modules are factory-installed, please take steps above to replace the modules if
necessary.
To Next Page
Loading...
Need help?
General
