FScurtis SEG-15 - User Manual

Questions and Answers

S
Sara ChavezAug 5, 2025
Why FScurtis SEG-15 Air Compressor will not start?
- N
  Nicole AndrewsAug 5, 2025
  If your FScurtis Air Compressor won't start, several factors could be the cause. First, check the power supply to ensure it's properly connected. Blown fuses in the control circuit can also prevent starting, so replace any blown fuses. Inspect all connections for loose or missing wires or components within the control circuit and secure them. Ensure that the voltage settings are correct for your system (e.g., not using 230 volts in a 460-volt system). A faulty temperature sensor may also be the culprit, so consider replacing it. Finally, check and adjust the oil separator pressure.
L
Lisa McdonaldAug 9, 2025
What to do if my FScurtis SEG-15 has a high temperature shutdown?
- M
  matthewmccarthyAug 9, 2025
  A high-temperature shutdown in your FScurtis Air Compressor can stem from several issues. Check for these potential causes: * Elevated ambient temperature: Reduce the ambient temperature around the compressor. * Low sump oil level: Refill the sump oil to the correct level. * Plugged oil filter: Replace the oil filter. * Restricted cooling airflow: Improve the cooling airflow around the unit. * Clogged heat exchanger: Clean the heat exchanger. * Thermal bypass leaking: Replace the thermal bypass. * Faulty high air temperature sensor: Replace the sensor. * Delivery pressure set too high: Adjust the delivery pressure settings. * Open panels: Ensure all panels are closed. * Restricted exhaust air: Clear any obstructions to the exhaust air.
T
Teresa BuckAug 13, 2025
Why FScurtis Air Compressor does not build up to the desired pressure?
- A
  Alan JimenezAug 13, 2025
  If your FScurtis Air Compressor isn't reaching the desired pressure, several factors could be responsible. Ensure the inlet valve is fully open. Check for belt slippage and tighten or replace the belt if necessary. Clean or replace a restricted inlet air cleaner. Reduce excessive air demand. Replace a defective pressure gauge. Adjust pressure limit settings if they are too low. Inspect and clean the separator if there's excessive pressure drop. Inspect and repair a solenoid valve that is stuck open. Inspect and service the air end for any malfunction. If the compressor is too small, consider upgrading to a larger one. Finally, inspect and adjust the safety valve if it keeps discharging.
K
katherinebrownAug 18, 2025
How to reduce high power consumption of FScurtis Air Compressor?
- A
  Audrey WallAug 18, 2025
  High power consumption in your FScurtis Air Compressor may be due to several reasons. A plugged separator or aftercooler can cause this, so clean them. Ensure the air pressure switch setting is correct by adjusting it. Verify and correct the line voltage if it's too low. Balance electrical phases if there's an imbalance. Inspect and repair the motor if imminent failure is suspected. Similarly, inspect and service the air end if imminent failure is suspected. Address belt slippage by tightening or replacing the belt. Finally, inspect and secure any loose electrical connections.
E
Eric ThompsonAug 22, 2025
Why FScurtis SEG-15 Air Compressor starts but shuts down immediately?
- M
  michael72Aug 22, 2025
  If your FScurtis Air Compressor starts but shuts down immediately, consider these potential causes. Replace the pressure transducer or timer if there's a failure. Reduce air temperature if it's too high. Inspect and secure any loose or missing electrical components. Adjust the pressure limit settings if they're set too low. Inspect the motor and load conditions if motor overloads trip. Verify and correct the voltage supply if it's too low.
M
Maria BenitezAug 27, 2025
What causes the safety valve to discharge on my FScurtis SEG-15 Air Compressor?
- B
  brenthallAug 27, 2025
  If the safety valve on your FScurtis Air Compressor is discharging, it could be due to several reasons. The over pressure may not be set correctly, so adjust the pressure settings. Inspect and repair the inlet valve if it's not closing properly in relation to air demand. Clean the separator if it's plugged. Replace the minimum pressure check valve if it's faulty. Finally, replace the safety valve if it's faulty.
D
Danielle SolomonAug 30, 2025
What to do if FScurtis Air Compressor will not load?
- D
  Douglas TurnerAug 30, 2025
  If your FScurtis Air Compressor won't load, it could be due to a few reasons. The pressure might be set too low; increase the pressure setting. The inlet valve may not be opening, so repair or replace it. A faulty solenoid valve could also be the cause; repair or replace it as needed.