User Manual Fugoo Style Bluetooth Speaker Model F6SP page 5 1/10/2020
If you hear "Pairing is unsuccessful.", try pairing again.
If you are using an iPhone or an iPad that has been previously paired to the
speaker, it may be necessary to 'Forget this Device', as follows:
1. Tap Settings.
2. Tap Bluetooth.
3. Tap the icon to the right of 'Fugoo'.
4. Tap 'Forget this Device'.
5. Tap 'Forget Device'.
As long as the speaker is in pairing mode, the iPhone should find the speaker
again, and pair with it.
Disconnecting from another Bluetooth device
To disconnect your Fugoo Bluetooth Speaker from a Bluetooth source device, you can:
• Click the (Bluetooth) button on your speaker.
• Move your speaker and the Bluetooth source device apart until they disconnect.
• Power off your speaker.
• Power off the source device.
• Power off Bluetooth on your source device.
• Plug an audio cable into the speakers audio input jack.
• Disconnecting temporarily interrupts the Bluetooth wireless link between the speaker
and the currently paired source device, which permits the speaker to re-connect with
another source device to which it has been previously paired.
• Click the Bluetooth button, the speaker will attempt to connect with the last source
device.
• The disconnected device will still be paired with the speaker, allowing the speaker to
reconnect with it later.
Reconnecting
• To reconnect to a Bluetooth source device to which you have previously paired, just
power on the speaker and the source device, and place them within 33 feet (10
meters) of each other. It’s also necessary that no cable be plugged into the audio
input jack. Typically, the speaker and the source device will reconnect automatically.
• If voice prompts are enabled, the speaker says "Connected".
Clearing all pairings
• To clear the Bluetooth pairings with all previously-paired source devices, turn the
speaker on, and then hold the (Bluetooth) button for ten seconds, until the
speaker says "All Bluetooth pairings cleared. Pairing mode. Use the Bluetooth
settings of your device to connect.”
Audio playback
Adjusting the volume
• Click the + (Volume up) or – (Volume down) buttons to raise or lower the volume.
Playback
To Next Page
Loading...
