5-22 2. Main Menu Screen
When [Display −−> Storage] Is Selected:
1. When [Display −−> Storage] is selected, the Storage Transfer screen below is displayed.
2. Data transfer start
Check [Folder Name] and [Storage File Information], and press the [Start] switch.
* If the access folders of the screen data and the storage device are given the same name, the
folder in the storage device will be overwritten.
If [Storage File Information] field is blank, a new file “DSP0000.BIN” will be created in the DSP
folder under the access folder.
3. During data transfer to data transfer completed
During data transfer, the [Start] switch changes to [Transferring]. When data has been transferred
successfully, the following message dialog is displayed. Press the [OK] switch.
* If any other message is displayed, refer to “Message Dialog Displayed during Data Transfer
(between TS and Storage)” (page 5-27).
Folder name currently selected
Starts [Display −−> Storage]
transfer.
Lights up during communication
with a storage device.
Moves back to the previous
screen.
Displays information of the
folder currently selected.
Remaining storage memory
capacity
Storage Transfer screen
[Storage File Information] switches to the information on the transferred data.
Transferring
Data transfer completed
To Next Page
Loading...
