18
３-３-８ Optional card Installation
Figure ３-11 Optional card connection
１. Remove the cover of INTERFACE OPTION on the back of UPS when
you connect an optional card.
２. If used dry contact signal, pass the cable through the window of a
rear panel.
３. If used dry contact signal, fix the cable to the terminal on the
substrate.
４. Make the rail of the slot slide into the card edge, and insert it up to
the interior.
５. Fix wiring from the terminal on the substrate to the rear of UPS by
using Cable Tie stuck on the card.
Cover
Optional card
Cable tie mount base
Cable
Cable tie
Optional card
To Next Page
Loading...