FCC Part 15
NOTE : This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.There limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generated, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures :
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician help.
Packing Content
First of all, Open the packing box and confirm contents in the table below.
Contact the service when there is insufficient something. There is the following
form/capacity in the UPS.
Capacity Rack&Tower Type Tower Type
1kVA PEN１０２J1RT PEN１０２J1C
1.1kVA PEN１５２J1RT/15 ―
1.5kVA PEN１５２J1RT ―
2.4kVA PEN３０２J1RT/30 ―
3kVA PEN３０２J1RT ―
UPS Packing parts
UPS 1set
Communication Cable 1set
CD 1set
User’s Guide（with Guarantee）
1set
Flange for Rack（Rack＆Tower Type only） 1set
Pedestal（Rack＆Tower Type only） 1set
３P-2P Change Plug（1kVA and 1.1kVA only） 1set
Wire Protection (3kVA Only) 2sets
To Next Page
Loading...