LED１
LED２
Chapter９
Optional card
The following card is prepared in the UPS with optional.
・Network Agent card（Option）
：Cooperation with Power Management Software (Power-SOL). It is
a card equipped with SNMP agent's function.
・Dry Contact card（Option）
：It is a card equipped with 4 Relay Outputs(Input abnormal, Low
battery, UPS alarm, On-Bypass). It provides with REPO (REMOTE
ON/OFF) function and the remote shutdown function
９-１ Network Agent Card
Externals are shown in Figure ９-1.
Figure ９-1 Network Agent Card
（1）Network port
The card communicates with the administrative terminal where power
supply management software Power-SOL was installed by way of the
network by using this communication port.
The transmission rate corresponds
to 10Mbps/100Mbps.
The hot-swap of the card is possible.
Figure ９-2 Network port
The pin layout and externals of the port and position of LED that shows
communication are shown in Figure ９-2
.
LED1: The state of 10BASE-T /100BASE-TX is shown.
LED2: The communication with UPS is shown.
To Next Page
Loading...