14 Problem Solving
512
Problem Solving
14
033-738
O [Cause] Received abnormal JBIG data.
[Remedy] No measure is required.
033-740
O [Cause] The printing of the received fax document was interrupted.
[Remedy] No measure is required.
033-741
O [Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not
resolved, contact our Customer Support Center.
033-742
O [Cause] An error occurred during fax transmission. This error may
occur if the remaining capacity of the machine's memory is
10% or less and Manual Send is used.
[Remedy] If this error was caused when using Manual Send, connect
the line after storing the document, and then send. If the
error still is not resolved, delete unnecessary data from the
hard disk to free up disk space, and execute the operation
again.
If the error persists, contact our Customer Support Center.
033-743
033-744
033-745
033-746
O [Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power.
Try again. If the error still is not resolved, contact our
Customer Support Center.
033-747
O [Cause] The job is temporarily suspended.
[Remedy] No measure is required.
033-749
O [Cause] The machine will automatically recover and print the
document.
[Remedy] No measure is required.
033-750
O [Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power.
Try again. If the error still is not resolved, contact our
Customer Support Center.
033-751
O O [Cause] An activity report output occurred during the printer lockout
duration. Outputting the activity report was suspended
because the machine was in the Sleep mode.
[Remedy] No measure is required because the machine will output
the report after exiting the Sleep mode.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
