Error Code
515
Problem Solving
14
047-216
O O O O O O [Cause] An error occurred while detecting the finisher.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the same message is displayed again, contact our
Customer Support Center.
047-217
O O O O O O [Cause] An error occurred while detecting Tray 6 (HCF B1).
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the same message is displayed again, contact our
Customer Support Center.
047-320
O O O [Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the same message is displayed again, contact our
Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
