Connectivity & Network Setup
183
Tools
5
Select this to set 100BASE-TX (Full Duplex) as the default value.
z
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
z
10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
z
10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
z
1000 Mbps
Select this to set 1000BASE-T as the default value.
Note • 1000BASE-T is not available for some models. An optional component is required.
TCP/IP - Common Settings
Configure common settings to use TCP/IP.
îš„ Primary Network
When two Ethernet interfaces are used, the name of interface which works as the primary
network is displayed.
Note • The primary network is "Ethernet 1". You cannot set "Ethernet 2" as the primary network.
• This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
You cannot edit the setting from here.
îš„ IP Mode
Allows you to select the TCP/IP operation mode.
Displays current IP mode.
z
IPv4 Mode
Select this option for IPv4.
z
IPv6 Mode
Select this option for IPv6.
z
Dual Stack
Select this option for an environment using both IPv4 and IPv6.
TCP/IP - Network Settings / TCP/IP - Network Settings (Ethernet 1), TCP/IP - Network
Settings (Ethernet 2)
Configure network settings other than common settings to use TCP/IP.
Important • Configuring same IP address for [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network
Settings (Ethernet 2)] is prohibited. When setting the same IP address to each Ethernet, contact our
Customer Support Center.
• Only LPD, Port9100, and SNMP ports are available for [TCP/IP - Network Settings (Ethernet 2)]. The
applications using any other ports such as Network Scanner Utility 3 may not work with the [TCP/IP -
Network Settings (Ethernet 2)] setting.
Note • We recommend you to specify different IP addresses between [TCP/IP - Network Settings (Ethernet
1)] and [TCP/IP - Network Settings (Ethernet 2)].
• The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [TCP/IP - Network Settings] is displayed. When two Ethernet interfaces
are used, [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)] are
displayed.
• For [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)], same
setting items as [TCP/IP - Network Settings] are displayed. You can configure individual settings for
each Ethernet interface.
To Next Page
Loading...
Need help?
General
