15 Problem Solving
598
Problem Solving
15
6 Remove the jammed staples as shown in the
illustration.
7 With holding the tabs, return the cartridge to
the original position, and then gently push the
cartridge in until it clicks into place.
8 Repeat steps 3 to 7 for the other cartridge.
9 Return the unit to the original position.
10 Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine remains
paused.
If you cannot remove jammed staples even after you perform the above procedure, contact
our Customer Support Center.
Be careful in removing jammed staples.
To Next Page
Loading...
