ESC/P-K Emulation
637
Appendix
16
Basic Settings
Setting Item
Item
Number
Value
Paper tray 3 Sets the paper tray to be used for printing.
[0] : Auto
[1] (Default) : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
[6] : Tray 6 (HCF (A4 1 Tray) or (A4 2 Tray))
[7] : Tray 7 (HCF (A4 2 Tray))
If printing from Tray 5, instruct printing and then operate the machine to
start printing. To cancel the setting, change the setting for "Tray 5
Confirmation".
Important • When Trays 1 to 4, or Trays 6 to 7 is selected, the paper size is determined
by the size of paper loaded in the tray, and thus [Paper Size] cannot be set.
Also, the paper size of for Trays 3 to 4 is fixed to A4. To change the paper
size, contact our Customer Support Center.
Note • When [Auto] is selected and paper of the same size in the same orientation
in multiple trays is loaded, paper will be fed in the order of Tray 1 J Tray 2
J Tray 3 J Tray 4 J Tray 6 J Tray 7. If paper of the same size is loaded
in multiple trays but in different orientations, feeding of the paper loaded
in the landscape orientation is prioritized.
Document size 1 Sets the client-created document size.
[99] (Default) : Paper
[100] : Continuous form paper (10 x 12)
[101] : Continuous form paper (10 x 11)
[102] : Continuous form paper (15 x 12)
[103] : Continuous form paper (15 x 11)
[3] : A3
[4] : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 x 14
[22] : 8.5 x 13
[23] : 8.5 x 11
[24] : 11 x 17
[0] : Postcard
The number of characters printed is: 80 characters/72 rows for continuous
form paper (10 x 12), 80 characters/66 rows for continuous form paper (10 x
11), 136 characters/72 rows for continuous form paper (15 x 12), and 136
characters/66 rows for continuous form paper (15 x 11).
Note • When a continuous form paper is selected for [Original Size], [Paper
Position] cannot be set.
• When [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the
machine automatically calculates the magnification based on a
combination of [Original Size] and [Paper Size]. If the ratio, however, is
outside the range of 45-210%, the document will not be reduced/
enlarged, and will be printed at a scale of 100%. When [2 Up] is selected,
the machine automatically calculates the magnification based on a
combination of [Original Size] and 1/2 of [Paper Size].
• The orientation set here is that of the document. It is not affected by the
orientation of paper loaded in the paper trays.
To Next Page
Loading...
Need help?
General
