15 Problem Solving
632
Problem Solving
15
3 Hold the tabs of the staple cartridge, and then
lift to remove it.
4 Remove the jammed staples as shown in the
figure.
5 Holding the tabs of the removed staple
cartridge, return the cartridge to the original
position and gently push it until it clicks into
place.
6 Return the unit to its original position.
7 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher is
even slightly open.
If the staples cannot be removed after carrying out the above procedures, contact our
Customer Support Center.
Staple Jams in the Staple Cartridge for the Finisher D2-P with Booklet Maker
The following describes how to clear staple jams in the staple cartridge when the Finisher
D2-P with Booklet Maker (optional) is installed.
Be careful in removing jammed staples.
To Next Page
Loading...
Need help?
General
