16 Appendix
672
Appendix
16
Adjust Image Transfer
This section describes how to adjust image transfer.
You can adjust the transfer output value when image transfer is poor.
Image Transfer Adjustment
Adjust the transfer output value for each paper type.
1 Load paper for adjusting the transfer output value in Tray 5 (Bypass).
2 Press the <Log In/Out> button, and enter the System Administration mode.
For how to enter the System Administration mode, refer to "System Settings Procedure" (P.128).
3 Select [Tools] on the Services Home screen.
4 Select [System Settings] > [Common Service Settings] > [Maintenance].
5 Select [Adjust Image Transfer].
6 Select [Paper Type].
7 Select the paper type you want to adjust, and
press [Close].
8 Adjust the value for image transfer.
To Next Page
Loading...
Need help?
General
