Tools
352
Tools
5
System Administrator's Passcode
Set the passcode for the system administrator.
Setting a passcode is strongly recommended to enhance security.
z
The default of the system administrator's passcode is “x-admin”.
The system administrator's passcode set here is used when [Passcode Entry for Control
Panel Login] is set to [On] under [Authentication/Security Settings] > [Authentication] >
[Passcode Policy].
Set the passcode after setting the system administrator's user ID. You can set the passcode
from 4 to 12 characters.
z
For more information about [Passcode Entry for Control Panel Login], refer to "Passcode Policy" (P.358).
1
Select [System Administrator's Passcode].
2
Select [New Passcode].
3
Enter a new passcode (4 to 12 digits) using the keyboard displayed, and then select [Save].
z
If no passcode is set, leave the text boxes blank and select [Save].
4
Select [Retype Passcode], enter the same passcode, and then select [Save].
5
Select [Save].
6
A confirmation window appears. Select [Yes] to confirm your entry.
Authentication
You can set the authentication settings.
Login Type
Allows you to select a type of authentication.
No Login Required
Does not use the Authentication feature.
Login to Local Accounts
Authenticates users based on the user information registered on the machine.
z
When [Login to Local Accounts] is selected, the machine enters the Login mode and [Login] is displayed at
the lower left of the Services Home screen.
To Next Page
Loading...
Need help?
General
