The GBC AdvancedPunch comes standard with 1 x Die PB-21 Hole A4 punch size (ED200557)
Additional Die’s are available for purchase from Fuji Xerox.
The approximate life of the Die is 500K punch cycles, replacement Die’s are not covered under the service agreement
and these can be purchased from Fuji Xerox Supplies.
Punch die life will be increased if the wick material is lightly oiled every 50,000 punch cycles (approximately every
month) with the initially supplied oil or a quality machine oil such as 3-in-1 Oil. The customer is responsible for applying
this oil. Small deposits of oil will be observed around the perimeter of the punched holes until the excess oil is absorbed
(usually within 20 sheets).
Please refer to the GBC AdvancedPunch User Guide for instructions.
To Next Page
Loading...
Need help?
General
