Space Requirements
Space requirements for the full system are listed earlier in this document
To enable a Fuji Xerox Service Representative to safely repair the server, the work area must measure at least 91.44 cm
square around the server.
The work surface of the network controller must not infringe on the space requirements by the print engine and any
attached accessories unless the work surface is a table that has wheels and can easily be moved. Refer to the print engine’s
Customer Expectation Document.
There must be a minimum of 198.12 cm clearance from the floor to the nearest overhead obstructions.
All standard Fuji Xerox space requirements apply to this installation including overhead, shared, aisle or hallway, and
operator space. The customer is responsible to provide appropriate floor spacing and placement surface.
Storage and future availability of software that ships with the colour server is a customer responsibility. Fuji Xerox
personnel do not carry replacement materials.
Note: Power cords for the EX Print Server and the Integrated Fiery Color Server EX-i are approximately 2.3 meters in length.
Specifications
To Next Page
Loading...
Need help?
General
