4 Machine Status
106
Machine Status
4
îš„New Value
Enter a new value.
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1 Select [Store/Delete Programming].
2 Select [Store Current Selections] or [Delete].
3 Select the memory number to store or to
delete.
îš„Store Current Selections
Stores the current selections. If you select a number already used, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
îš„Delete
Deletes a number selected. Select [Delete] and then select a number to delete.
Important • Deleted numbers cannot be restored.
Default Programming
You can start the machine using the settings stored in memory as default settings.
1 Select [Default Programming].
2 Select [Factory Defaults] or [Custom
Settings].
3 When you select [Custom Settings], select a memory number to use.
4 Select [Save].
îš„Factory Defaults
You can use the factory default settings.
îš„Custom Settings
Displays the numbers stored in memory.
Password
For PDF Direct Print, if a password is set for files, set the password here in advance.
PDF files can only be printed when the passwords assigned and entered are the same.
You can use up to 32 characters for the password.
To Next Page
Loading...
Need help?
General
