Activity Report
655
Appendix
15
Activity Report
You can print activity reports to check whether a transmission is successfully
completed or not. In the report, a remote terminal name and a result or a status of each
operation are recorded by outgoing and incoming transmission.
For information on how to print the activity report, refer to "Print Reports" (P.95).
Item Description
No. The serial numbers for transmissions is shown.
Doc. Job numbers that the machine automatically assigned to
documents when the documents were received.
Remote Station Information on recipient to which transmission is made is
recorded in the following order of priority.
îš„Transmitting (speed dialing)
cRecipient
dRemote terminal name
eG3 ID (including spaces)
fTel. No.
gCommunication mode EC (or G3, SG3)
îš„Transmitting (when all digits are dialed)
cRemote terminal name
dG3 ID (including spaces)
eTel. No.
fCommunication mode EC (or G3, SG3)
îš„Receiving
cRemote terminal name
dG3 ID (including spaces)
eCommunication mode EC (or G3, SG3)
Note • You can set the number of character digits displayed for
the recipient whether the first 40 digits or the last 40
digits. For details on setting up, see "Activity Report -
Recipient" (P.144). The factory default displays the first
40 digits.
Start Time The date and time that the communication began are shown.
In Batch Send, the start time of the transmission for each doc-
ument is recorded.
Duration The duration of the transmission is displayed. In Batch Send,
it is the length of time taken to transmit each document is
recorded.
Pages "-" is shown when the number of pages is 0.
îš„Transmitting
The number printed on the left side of the slash "/" indicates
the number of pages that were successfully transmitted. The
number printed on the right side of the slash "/" indicates the
number of total pages. In Batch Send, the number of total
pages is not shown.
îš„Receiving/Polling
The number of pages that the machine successfully received
is shown.
Mode The mode used for the communication is shown.
There are three modes: G3, EC, and SG3 (Super G3). (This
field is blank if a mode other than above these was used.)
To Next Page
Loading...
Need help?
General
