Changing the Paper Size
51
Paper and Other Media
2
Changing the Paper Size for Tray 6 (HCF B1)
The following describes how to change paper size in Tray 6 (HCF B1).
1 Pull out the Tray 6 until it stops.
Important • While the machine is processing a job, do
not pull out the tray that is being used for the job.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do
not add paper on top of any remaining paper in the tray.
2 Remove any paper loaded in the tray.
3 Open the end guide (1) and unscrew the
screw (2). And then remove the guide from
the tray.
4
Insert the small protrusions at the bottom of the guide into the holes corresponding to
the paper size (1). Insert the protrusion on the tray into a hole corresponding to the
paper size on the top of the guide, and tighten up the screw (2).
5 Unscrew the screw of the front guide and
remove the guide from the tray.
CAUTION
Make sure to pull out the tray slowly. If
the tray is pulled out with too much
force, the tray might possibly hit your
knees or other parts of your body and
cause injuries.
To Next Page
Loading...
Need help?
General
